Logo

C2170 Engine Trouble Code

Meaning of C2170 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C2170 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C2170 code is occuring now you should check C2170 repair processes.
Now don't ask yourself; What should you do with C2170 code ?
The solution is here :

C2170 Possible Solution:

C2170 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

C2170 Code Meaning :

C 2 1 7 0
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Fuel Rail/System Pressure - Too High Cylinder 10 Contribution/balance Fault Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C2170 OBD-II Diagnostic Chassis (C) Trouble Code Description

C2170 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For C2170 Code

The reason of C2170 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

C2170 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.